2. Scenario - MERGEXML

Page / - last modified by Assala Chmiti on 2022/06/13 13:18

MERGEXML

last modified by Assala Chmiti

on 2022/06/13 13:18

Table of Contents

I- Introduction:

I- Treatment Features:

Remark:

I- Introduction:

The "MergeXML" connector is used to merge different XML files into one XML file.

I- Treatment Features:

The "MergeXML" connector is found in the conectors panel (On the left sidebar of the scenario page).

Configuration:

To set up the connector, you should click on the blue button above the connector and fill in the properties displayed :

Figure 1: The MERGEXML connector

Name : To give a name to the processing step (connector). It is very useful to give meaningful names.

Nœud XML : Contains the XML node allowing to merge the XML content in the same file.

Output FileName : define the Name of the output file.

Condition : This field allows you to add a condition to execute the processing step only if the condition is met.

Figure 2: Properties of the MERGEXML connector

Example: MERGEXML using 2 Files IN

In this example, we will try to merge 2 files IN into one output file.

1-Input files of the MERGEXML connector

You will find below the 2 files example.

Figure 3: Content of the 1st input file in the MERGEXML connector

Figure 4: Content of the 2nd input file in the MERGEXML connector

1-Output file after the MERGEXML connector

By using 2 different configurations (Figure 5 and Figure 7) of the MERGEXML connector, we obtain successively the following result file (Figure 6 and Figure 8):

Figure 5: 1st MERGEXML connector configuration

Figure 6: Content of the OutputFile of the MERGEXML connector of the 1st Configuration

Figure 7: 2nd MERGEXML connector configuration

Figure 8: Content of the OutputFile of the MERGEXML connector of the 2nd Configuration

Remark:

The XML node in the properties of the MERGEXML connector is the one that determines the content of the output File.